Step 1: Take out the basin faucet and check if all accessories are complete. Before installation, it is necessary to remove dirt around the device hole and in the water supply pipeline to ensure that there are no impurities in the inlet pipeline of the basin faucet. To maintain the surface of the faucet from being scratched, it is recommended to wear gloves for installation.
Step 2: Take out the rubber gasket of the basin faucet, which is used to relieve the pressure on the metal surface of the faucet in contact with the ceramic basin, maintain the ceramic basin, then insert a water inlet pipe and tighten it.

Step 3: Thread the threaded joint into the first inlet hose on the list, and then thread the inlet end of the second inlet hose through the threaded joint.

Step 4: Screw the second inlet hose into the inlet port, pay attention to the correct direction, apply force evenly, and then tighten the threaded joint.
Step 5: Thread two water inlet hoses into a white rubber pad, tighten the locking nut to secure the faucet, and then tighten the sleeve.
Attention: Do not tighten the interface between the two inlet pipes and the angle valve. Do not use pipe pliers to fully twist the plate to prevent deformation or even breakage. Pay attention to the connection between hot and cold water. Connect the other end of the inlet pipe to the outlet angle valve.
Article source: Flat disc faucet manufacturer www.baolonghs.com