First, install the tool:
Hoses, rubber gaskets, showerheads, dehydrators, crutches, decorative caps, etc., must be checked for complete matching parts before installation each time.
Installation steps:
1. Installation of single hole basin faucet
When purchasing a handmade basin faucet, attention should be paid to the diameter of the water outlet. Currently, most markets have hard pipes for water inlet, so you should pay attention to reserving the height of the water outlet. It is most suitable to move 35 minutes from the basin downwards. When installing, it is necessary to choose a dedicated angle valve, which must be fixed to the cold and hot water pipes of the wall outlet. When you notice a gap between the angle valve and the faucet water pipe, purchase a dedicated extension pipe to connect it. Remember, never use other water pipes to connect, as if the water pressure is high, it can easily fall off and leak, causing damage to you. If the inlet pipe is too long and exceeds the outlet pipe, you can cut off the department according to your needs. If the angle is different, you can bend it moderately to the position you need. Remember: Do not bend hard to 90 degrees or greater. When installing the basin to drain water, please do not forget to purchase the small connector of the faucet (faucet short circuit). Before you install, please don't forget to flush the water pipes buried in the wall in advance.
2. Installation of shower and bathtub faucets (wall mounted)
After purchasing a shower, bathtub, or wall mounted faucet, you can choose the appropriate height to bury the water pipe. The distance between cold and hot water pipes must reach 15 centimeters. Before installation, you must not forget to flush the water pipe to avoid excessive water quality and damage to the faucet.
3. Concealed shower and bathtub faucet
After purchasing a concealed faucet, it is generally necessary to embed the valve core of the faucet in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the valve core will not be embedded. Do not remove the plastic protective cover of the valve core during pre embedding to avoid damage to the valve core caused by cement and other miscellaneous tasks. In addition, when embedding the valve core, attention should also be paid to the up, down, left, and right directions of the valve core to prevent it from being buried incorrectly. There is a deviation in the size of the embedded water inlet pipe for wall mounted faucets, and adjustable hooks can be used for positioning.
4. Installation of thermostatic faucet
Before installing the thermostatic faucet, please check if the water pipe is hot on the left and cold on the right. Remember not to connect the cold and hot water pipes incorrectly to prevent the faucet from working properly. Gas and solar water heaters cannot use thermostatic faucets due to low water pressure. Please do not forget to install a cold and hot water filter when installing a thermostatic faucet.
5. Installation of single hole kitchen faucet
Stability is required. Due to the frequent use of kitchen faucets and their tendency to loosen when moved around, the locking nut must be tightened. At present, there are some faucets in the market that have increased the nut fixation for the screw tube, which has a good stabilizing effect. If the problem of water removal and lifting can be solved, it will be a popular trend in the future.



Reading source: Kaiping bathroom faucet manufacturer www.baolonghs.com