1. When installing this type of faucet, make sure that its sensing window is facing downwards and the distance between it and the bottom of the sink is at least 25CM, otherwise it will affect its sensing sensitivity.

2. To ensure the installation of the faucet, the water source at the inlet where the sensing faucet is about to be installed must be turned off.

3. Take out the faucet body from the packaging, wrap the inlet thread on the faucet body with raw material tape or anti leakage glue, and screw the faucet body into the position where the inlet pipe is to be installed on the wall.

4. Open the battery box cover on the protruding part of the top cover above the sensing faucet body, carefully pull out the battery box inside, and insert 4 new No. 3 alkaline batteries into the positive and negative poles according to the instructions. At this time, the red light on the sensing window on the faucet body will continuously flash. After the red light on the sensing window on the faucet body stops flashing inside, push in the battery box and lock it, so that the faucet body is finally installed.

5. Open the water source at the location where the faucet is about to be installed for testing, and adjust the water output with the water valve knob. If there are no problems, it can be put into use.

More content: kaiping bathroom faucet manufacturer   www.baolonghs.com